Sanding Down And Painting Kitchen Cabinets

If the cabinets are stained or coated with a single layer of clear finish you may not need to use paint stripper.

Sanding down and painting kitchen cabinets. This video shows you exactly how i repainted my old varnished oak kitchen cabinets. Instead of sanding chris and lexi use mineral spirits and a rough scrubbing pad to clean the cabinets thoroughly before priming them. Allow the filled areas to dry then use sandpaper to smooth out the surface of the cabinets. I gave my kitchen a whole new look for 250 all of the supplies i used ca.

Laminate cabinets require a special bonding primer. Choose a high quality paint. Steps for painting kitchen cabinets without sanding follow these steps for painting your cabinets without the added step of sanding them down first. Buy a cabinet painting kit and get the paint tinted to your preference.

Mask off the interiors with painters tape for a clean finish and sand only the front surfaces and visible edges of the cabinet face frames. Even if your cabinets are in near perfect condition you still have to sand them so the paint will stick use sandpaper in the middle of the spectrum 150 or 200 grit is good. The laminate must be in good condition for best results. Sanding the kitchen cabinet doors and frames is hard work but pretty straightforward.

Sand the finish from the cabinets trim and drawers with 120 grit sandpaper. If your repainting project is just a facelift for the cabinets you don t need to sand and paint the inside of the cabinets. Good commercial kits contain a de glosser to remove any older coats of paint on existing cabinetry. This not only cleans the cabinet paint doesn t go on well over grease but the scrubby sponge also roughs up the surface just enough to make the primer stick.

Wood cabinets are ideal for painting but any surface that can be scuffed with sandpaper can be painted. Sanding creates a smooth cabinet surface gets rid of minor scratches and prepares the wood to better absorb the new finish. Proper sanding is necessary to get a smooth final coat of paint or stain. I used my ryobi orbital sander on all the flat surfaces basically anything it could reach and used the sanding blocks for the smaller harder to reach moldings and corners.

The key here is to sand some of the existing.